Tesla has initiated a rare physical recall for the 2016 Model X SUV. As per the National Highway Traffic Safety Administration’s (NHTSA) Safety Recall Report, a total of 9,136 units of the 2016 Model X that were produced through July 31, 2016 are affected by the issue.
The Tesla Model X is equipped with a cosmetic front appliqué just behind the windshield, as well as a spine appliqué at the center of the roof in between the falcon door roof glass. Both appliqués are attached to the vehicle using urethane. If not enough primer was used in the appliqué-to-urethane interface, the adhesion of the part could weaken, and the appliqué could separate from the Model X. Such an issue could be a traffic hazard, especially if the appliqué comes off while the 2016 Model X is in motion.
Interestingly enough, Tesla already initiated a physical recall in November 2020 to inspect 2016 Model X units for proper appliqué retention. At the time, Tesla used an inspection method that involved pulling the appliqué in several areas with a maximum force of 60N. If the components weathered the 60N pull inspection, they were not replaced. Tesla has now determined that either the inspection pull force or the location and number of locations where the pull force was applied in the 2020 recall were not sufficient to accurately identify faults in the component.
To address this issue, Tesla will be inspecting affected 2016 Model X vehicles and perform an improved retention test with a higher pulling force at a minimum of 120N. If the appliqué passes the retention test and shows sufficient adhesion, then no further action would be necessary. If the appliqué fails the retention test, Tesla Service will reattach the affected component using the proper primer and urethane procedure. A full replacement for the appliqué would also be performed if needed.
It should be noted that the appliqué issue seems to be present only on 2016 Tesla Model X units that were produced through July 31, 2016. Following this date, the supplier of the component implemented new processes to standardize and document its primer application, addressing the appliqué adhesion issue.
The NHTSA’s Safety Recall Report about the 2016 Tesla Model X’s appliqué issue can be viewed below.
RCLRPT-24V615-6995 by Simon Alvarez on Scribd
Don’t hesitate to contact us with news tips. Just send a message to [email protected] to give us a heads up.
News
Tesla gets new information request from NHTSA on Robotaxi rollout
Tesla has been contacted by the NHTSA regarding plans for the Robotaxi rollout and how it will handle poor weather.

Tesla has been contacted by the National Highway Traffic Safety Administration (NHTSA) regarding its planned rollout of a Robotaxi platform in Austin, Texas.
The agency sent a letter to Tesla Field Quality Director Eddit Gates, seeking more information on exactly how the company plans to operate the fleet in poor weather conditions. The NHTSA wants to know how Tesla’s technology and operational use cases will “assess the ability of Tesla’s system to react appropriately to reduced roadway visibility conditions.”
Additionally, the NHTSA said it would like additional information on Tesla’s development of technologies for use in ‘robotaxi’ vehicles to understand how Tesla plans to evaluate its vehicles and driving automation technologies for public roads.
Tesla has already started operating a supervised version of the Robotaxi platform for employees in both Austin and San Francisco. This limited rollout has completed thousands of rides already, but differs from the version it plans to roll out in the coming weeks in Austin, as it currently has a driver sitting in the driver’s seat.
Tesla says it has launched ride-hailing Robotaxi teaser to employees only
They are there to supervise the vehicle and ensure safety early on in the program.
The letter that was sent to Tesla on May 8 is part of a greater investigation that was opened by the NHTSA on October 17, titled “FSD Collisions in Reduced Roadway Visibility Conditions.”
The agency said the purpose of the “Preliminary Evaluation of FSD” was to assess:
- The ability of FSD’s engineering controls to detect and respond appropriately to reduced roadway visibility conditions;
- Whether any other similar FSD crashes have occurred in reduced roadway visibility conditions and, if so, the contributing circumstances for those crashes; and
- Any updates or modifications from Tesla to the FSD system that may affect the performance of FSD in reduced roadway visibility conditions. In particular, this review will assess the timing, purpose, and capabilities of any such updates, as well as Tesla’s assessment of their safety impact.
Tesla is required to respond to the NHTSA’s request by June 19.
INIM-PE24031-62887 by Joey Klender on Scribd
News
Potential affordable Tesla “Model 2/Model Q” test car spotted anew in Giga Texas
The recent footage featured an apparent test car that looks very similar to a vehicle that was spotted in the Fremont Factory last month.

Tesla has been very secretive about the “more affordable models” that it intends to start producing in the first half of 2025, but the company does seem to be quite busy testing something interesting in the Giga Texas complex. This was, at least, as per recent aerial footage from a longtime Giga Texas watcher.
The recent footage featured an apparent test car that looks very similar to a vehicle that was spotted in the Fremont Factory last month.
New Giga Texas Sighting
In a post on X, longtime Giga Texas watcher and drone operator Joe Tegtmeyer noted that he recently spotted a rather unique test car in the factory complex. The vehicle was under a car cover, but it was evidently missing its body panels and roof. Interestingly enough, it seemed to be shaped like a Model Y (it even had Model Y wheels), though it looked a bit more compact than another Model Y that was parked next to it.
Interestingly enough, a rather similar test car was spotted at another Tesla plant, the Fremont Factory in California, last month. Tesla watcher Met God in Wilderness, who has been posting aerial videos of the Fremont Factory for years, shared some footage from a drone flyover in mid-April. One of the vehicles captured in the flyover was an apparent test car that was parked next to fully-built Model Y and Model S vehicles. The test car in this sighting also looked like a compact crossover, and it was also missing its roof and body panels.
Tesla’s Affordable Cars
In the Q1 2025 Update Letter, Tesla noted that “plans for new vehicles, including more affordable models, remain on track for start of production in the first half of 2025.” In the Q1 earnings call, Tesla VP of Vehicle Engineering Lars Moravy stated that Tesla’s affordable cars would resemble the company’s existing vehicles, though they will be more affordable.
These comments suggested that Tesla’s affordable cars, which have been informally dubbed by the EV community as the “Model 2 or Model Q,” will look a lot like its two mass market vehicles, the Model 3 sedan and the Model Y crossover. “Models that come out in the next months will be built on our lines and will resemble, in form and shape, the cars we currently make. And the key is that they’ll be affordable, and you’ll be able to buy one,” Moray stated.
Elon Musk
Elon Musk invited to attend investment summit in Saudi Arabia: report
Musk’s reported invitation comes on the sidelines of United States President Donald Trump’s visit to the Middle East.

A planning note reported viewed by Reuters has indicated that Tesla CEO Elon Musk has been invited to a Saudi-U.S. investment forum in Riyadh, the capital of Saudi Arabia. The event is expected to be held on Tuesday.
Musk’s reported invitation comes on the sidelines of United States President Donald Trump’s visit to the Middle East.
Musk’s Invitation
As per Reuters, the upcoming investment forum is expected to be attended by some of the most distinguished people in the investment world. These include the CEOs of high-profile companies such as Blackrock, Citigroup, IBM, Boeing, Delta Airlines, American Airlines, and United Airlines, among others, the publication noted.
Considering the other attendees of the event, Elon Musk would likely fit right thanks to his leadership of companies like Tesla, SpaceX, and xAI, as well as his close ties with the Trump administration through his work at the Department of Government Efficiency (DOGE).
Musk and Saudi Arabia
Elon Musk’s relationship with Riyadh have notably improved since the start of Trump’s second term as United States president. Highlighting this improvement was Tesla’s launch in Saudi, which was held in April. Tesla’s launch was a notable event based on videos posted of the occasion, with the company showcasing some of its most exciting products, including Optimus, the Cybertruck, and the Cybercab, its self-driving robotaxi.
Tesla’s launch in Saudi Arabia, as well as his reported invitation to the upcoming investment forum, suggests that the CEO’s feud with Yasir Al Rumayyan, head of the $925 billion Public Investment Fund, has ended. The PIF Head was among the people involved in Elon Musk’s infamous “funding secured” tweet in 2018, which resulted in hefty fines and his removal as Tesla’s Board Chair. The PIF also sold its Tesla holdings and invested in another EV company, Lucid Group Inc.
-
News1 week ago
Tesla offers legacy Model Y owners an interesting promotion
-
News4 days ago
Tesla Cybertruck Range Extender gets canceled
-
News2 weeks ago
Waymo considers selling robotaxis to individual owners
-
News2 weeks ago
Tesla posts Semi factory update, shares new Semi logo design
-
News2 weeks ago
Tesla opens whopping 83 job listings for Semi program
-
News2 weeks ago
Like it or not, the new Tesla Model Y is a big hit in China
-
News2 weeks ago
Tesla Model Y with three rows and extended wheelbase rumored to start production in China
-
News2 weeks ago
Berlin Senator calls Tesla “Nazi” cars, pisses off Brandenburg because Giga Berlin is a giant employer